Windows 10 is an outstanding working machine, but, installation system of windows 10 isn’t usually easy. Talking of which, numerous users pronounced “the laptop restarted ” loop even as looking to install home windows 10. This could be a big problem. However, there are numerous answers available that you can attempt.
Fix “The computer restarted unexpectedly” loop while installing Windows 10.
Alternative Solution 1 – Use Registry Editor
To repair this problem, you’ll need to use the registry editor. To do this, comply with these steps:
- While you see “The computer restarted unexpectedly” error message, you must press Shift + F10 on your keyboard. This should open Command Prompt(CMD).
- Type regedit and next press Enter to open Registry Editor.
- Once Registry Editor starts, look to the HKEY_LOCAL_MACHINE\SYSTEM\Setup\Status\ChildCompletion and double-click the setup.exe in the right pane.
- Modify the Value Data from 1 to 3 and click OK to save changes.
- Close Registry Editor and restart your computer.
Alternative Solution 2 – Check your hard drive cables.
Once in a while, you would possibly get stuck in “the laptop restarted all at once” loop because of difficult drive cable problems. Users said that switching the cables that join immense power to the motherboard fixed the difficulty, so you may want to attempt that.
Alternative Solution 3 – Reset your BIOS settings and format the installation partition
Few customers propose that you could restore the “the laptop restarted abruptly” loop by way of resetting your bios and putting your USB flash force as a primary boot device. To peer the way to try this, talk to your motherboard guide for certain commands.
When you’ve made all of the vital changes in bios, you need to layout your partition through using the diskpart device. To do that, comply with those steps:
- First, Boot from your USB flash drive and if you view “The computer restarted unexpectedly” error message, press Shift + F10 to run Command Prompt.
- When Command Prompt opens, enter diskpart and press Enter.
- Enter list volume and press Enter. You should view a list of all partitions available. Discover the partition on which you want to install Windows 10 and remember its Volume number.
- Enter select volume 1. Example: We used volume 1, but you require to use the volume that equals your partition.
- Enter format fs=ntfs quick label=test and press Enter. You can replace test with several another name you want to apply for your partition. We have to caution you that by executing this command you’ll eliminate all files and folders from the chosen partition.
- Type exit and press Enter to exit Command Prompt(CMD).
- After you restart your computer, the problem with “The computer restarted unexpectedly” loop should be fixed.
However, with any luck, you’ll be capable of restoration it through the usage of one among our answers.